LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Quick Connect Fitting(s) Service (Plastic Collar) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Twisting Quick Connect Fitting
    GM157703Courtesy of GENERAL MOTORS CORP.
  1. Grasp both sides of the quick connect fitting and twist 1/4 turn in each direction in order to loosen any dirt.
    2. CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
    Fig 2: Blowing Dirt Out Of Fitting (Plastic Collar)
    GM155410Courtesy of GENERAL MOTORS CORP.
  2. Remove any dirt, dust, or other foreign material from the quick connect fitting with compressed air.
    3. Fig 3: Squeezing Quick Connect Fitting Release Tabs (Plastic Collar)
    GM12777Courtesy of GENERAL MOTORS CORP.
  3. Squeeze the release tabs on the plastic retainer.
    4. Fig 4: Pulling Connection Apart (Plastic Collar)
    GM12778Courtesy of GENERAL MOTORS CORP.
  4. Pull the quick connect fuel fitting apart. Use a shop towel to catch any remaining fuel that may leak from the fuel line and the fitting.
scientia non olet · About LEMON Manuals