LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Positive Crankcase Ventilation Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: PCV Valve, Hose Clamp And Valve Hose
    GM607626Courtesy of GENERAL MOTORS CORP.
    NOTE: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
  1. Install the PCV valve (1) into the cylinder head.

    Tighten:  Tighten the PCV valve to 27 N.m (13 lb ft).

  2. Connect the PCV valve hose (3) to the PCV valve (1).
  3. Secure the PCV valve hose with one clamp (2).
scientia non olet · About LEMON Manuals