LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Electrical Connector, Air Cleaner Housing, Mass Air Flow (Maf) Sensor And O-Ring
    GM828876Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (1) from the mass air flow (MAF) sensor (4).
  2. Remove the two fasteners.
  3. Remove the MAF sensor (4) from the air cleaner housing (2).
  4. Remove the O-ring (3).
scientia non olet · About LEMON Manuals