LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Knock Sensor And Nut
    GM848007Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
  2. Disconnect the knock sensor (KS) electrical connector.
  3. Remove the nut (1) securing the KS (2) to the engine block.
  4. Remove the KS (2) from the engine block.
scientia non olet · About LEMON Manuals