LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Ignition Coils And Bolt
    GM830280Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coils (3) to the engine.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Secure the ignition coils with the fasteners (4).

    Tighten:  Tighten the ignition coil fasteners to 9 N.m (80 lb in).

  3. Install the electrical harness (2) and secure with the 2 fasteners (1).

    Tighten:  Tighten the fasteners to 8.8 N.m (78 lb in).

  4. Connect the electrical connectors to the ignition coils (3).
    5. Fig 2: View Of Engine Upper Cover
    GM828878Courtesy of GENERAL MOTORS CORP.
  5. Install the engine cover (1) to the engine.
  6. Secure the engine cover (1) with the four fasteners.

    Tighten:  Tighten the fasteners to 7 N.m (62 lb in).

scientia non olet · About LEMON Manuals