LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Position 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: The HO2S 1 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating prior to installation.
    Fig 1: HO2S 1, Wiring Pigtail And Body Plug
    GM851410Courtesy of GENERAL MOTORS CORP.
  1. Install the HO2S 1 (2) into the exhaust pipe.
    2. NOTE: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
  2. Tighten the HO2S 1.

    Tighten:  Tighten the HO2S 1 to 44 N.m (32 lb ft).

  3. Install the HO2S 1 wiring pigtail and body plug (1) into the floor pan.
  4. Lower the vehicle.
    5. Fig 2: Carpet, Retaining Pin, And Front Floor Console
    GM851369Courtesy of GENERAL MOTORS CORP.
  5. Connect the HO2S 1 electrical connector.
  6. Install the carpet (2) around the front floor console (3).
  7. Secure the carpet to the front floor console with the retaining pin (1).
scientia non olet · About LEMON Manuals