Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Relieve the fuel pressure. Refer to Fuel Pressure Relief Procedure .
- Remove the four fasteners from the engine cover (1).
- Remove the engine cover (1) from the engine.
- Remove the quick connect coupling cover of the fuel feed hose.
- Using the J 43178 , disconnect the quick connect coupling of the fuel feed hose from the fuel feed pipe of the fuel rail. See Special Tools . Use a shop towel in order to catch any remaining fuel that may leak. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
- Install the J 42982 between the fuel feed pipe of the fuel rail and of the fuel feed hose. See Special Tools .
- Install the J 34730-1A to the J 42982 , and tighten securely. See Special Tools .
- Connect the negative battery cable.
Tighten: Tighten the retainer for the negative battery cable terminal to 15 N.m (11 lb ft).
- Turn ON the ignition in order to pressurize the fuel system.
- Turn OFF the ignition.
- Check for any fuel leaks.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.