LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) System Vacuum Leak Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Vacuum Leak Pump
    GM1459177Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP vacuum leak pump (2) to the EVAP canister (3) and secure with 3 bolts.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Tighten the pump bolts.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  3. Connect the vacuum hose to the small port of the EVAP leak pump.
  4. Connect the EVAP filter line to the inlet port (4) of the vacuum leak pump (2)
  5. Install the EVAP canister to the vehicle. Refer to Evaporative Emission (EVAP) Canister Replacement .
scientia non olet · About LEMON Manuals