LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of ORVR Vent And Line
    GM1468454Courtesy of GENERAL MOTORS CORP.
  2. Unlock the quick connect fitting of the on-board refueling vapor recovery (ORVR) vent line by sliding the lock clasp (1) to unlock position.
  3. Disconnect the ORVR vent line (3) from the evaporative emission (EVAP) canister port (2).
    4. Fig 2: View Of EVAP Canister Air Inlet Line And Vent Pipe
    GM1468453Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP canister air inlet line (1) from the vent pipe (2) by pinching both sides of the hose connector.
    5. Fig 3: View Of EVAP Canister And Purge Hose
    GM1459178Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the EVAP purge hose (1) from the EVAP canister (3).
  6. Disconnect the electrical connector (4) from the EVAP canister vacuum pump assembly.
  7. Remove the 3 bolts and the EVAP canister (3) from the vehicle.
  8. Inspect the EVAP purge system for carbon particle contamination before replacing the EVAP canister.
scientia non olet · About LEMON Manuals