LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister And Purge Hose
    GM1459178Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (3) to the vehicle underbody and secure with 3 bolts.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Tighten the EVAP canister bracket support bolts.

    Tighten:  Tighten the bolts to 19 N.m (14 lb ft).

  3. Connect the EVAP purge hose (1) to the EVAP canister (3).
  4. Connect the electrical connector (4) to the EVAP canister vacuum pump.
  5. Connect the ORVR vent line (2) to the EVAP canister (3).
  6. Slide the locking clasp of the quick connect fitting into the lock position on the ORVR vent line
    7. Fig 2: View Of EVAP Canister Air Inlet Line And Vent Pipe
    GM1468453Courtesy of GENERAL MOTORS CORP.
  7. Connect the EVAP canister air inlet line (1) to the vent pipe (2).
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals