LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Purge Valve Components
    GM1468452Courtesy of GENERAL MOTORS CORP.
  1. Insert the locator pin (3) of the purge valve into the mounting hole on the air inlet duct.
  2. Connect the 2 vacuum hoses (4) to the EVAP canister purge valve (2).
  3. Connect the electrical connector (1) to the EVAP canister purge valve (2).
scientia non olet · About LEMON Manuals