LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Use care when handling the engine coolant temperature (ECT) sensor. Damage to the ECT sensor will affect proper operation of the fuel injection system.
    Fig 1: ECT Sensor And Electrical Connector
    GM641349Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine coolant. Refer to Draining and Filling Cooling System in Engine Cooling.
  2. Disconnect the ECT sensor electrical connector (1) from the ECT sensor (2) located next to the upper radiator hose on the cylinder head.
  3. Remove the ECT sensor (2) from the cylinder head.
scientia non olet · About LEMON Manuals