LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: ECT Sensor And Electrical Connector
    GM641349Courtesy of GENERAL MOTORS CORP.
    NOTE: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
  1. Install the ECT sensor (2) into cylinder head.

    Tighten:  Tighten the ECT sensor to 20 N.m (14 lb ft).

  2. Connect the ECT sensor electrical connector (1).
  3. Refill the engine coolant. Refer to Draining and Filling Cooling System in Engine Cooling.
scientia non olet · About LEMON Manuals