LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Stone Shield, Four Retainers And Two Bolts
    GM830841Courtesy of GENERAL MOTORS CORP.
  2. Remove the two bolts (3) that secure the stone shield (1).
  3. Remove the four retainers (2) and the stone shield (1).
    4. Fig 2: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the CKP sensor electrical connector.
  5. Remove the one hold down bolt (2).
  6. Remove the CKP sensor (1) from the front cover of the engine block.
scientia non olet · About LEMON Manuals