LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (1) into the front cover of the engine block.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the CKP sensor hold down bolt (2).

    Tighten:  Tighten the hold down bolt to 9 N.m (80 lb in).

  3. Connect the CKP sensor electrical connector.
    4. Fig 2: Stone Shield, Four Retainers And Two Bolts
    GM830841Courtesy of GENERAL MOTORS CORP.
  4. Install the stone shield (1) with the four retainers (2).
  5. Secure the stone shield (1) with the two bolts (3).

    Tighten:  Tighten the two shield bolts to 10 N.m (89 lb in).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals