LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Upper Cover
    GM828878Courtesy of GENERAL MOTORS CORP.
  1. Remove the four fasteners from the engine cover (1).
  2. Remove the engine cover (1) from the engine.
    3. Fig 2: CMP Electrical Connector And CMP Sensor
    GM830788Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the CMP electrical connector (1).
  4. Remove the two CMP sensor hold-down bolts.
  5. Remove the CMP sensor (2) from the cylinder head.
scientia non olet · About LEMON Manuals