LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the mass air flow (MAF) sensor.
  2. Remove the accelerator cable from the cable guide wire.
  3. Remove the auxiliary intake air control solenoid from the air cleaner cover. Refer to Auxiliary Intake Air Control Solenoid Replacement .
  4. Remove the evaporative emission (EVAP) canister purge valve from the air cleaner cover. Refer to Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement .
  5. Disconnect the vacuum hoses from the auxiliary intake air control system.
    6. Fig 1: Air Cleaner Hose And Cap Assembly
    GM847992Courtesy of GENERAL MOTORS CORP.
  6. Release the 2 retaining clips (3).
  7. Loosen the air inlet duct clamp (1).
  8. Disconnect the air inlet duct at the throttle body (1).
    9. Fig 2: Air Cleaner Components
    GM847995Courtesy of GENERAL MOTORS CORP.
  9. Remove the air cleaner upper assembly (2).
  10. Remove the air cleaner element (3).
  11. Remove the 3 bolts (5) from the air cleaner lower assembly.
  12. Remove the air cleaner lower assembly (4) from the vehicle.
scientia non olet · About LEMON Manuals