LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Controls Cable Replacement (Cruise Actuator to Throttle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Cruise Control Cable Components
    GM181797Courtesy of GENERAL MOTORS CORP.
  1. Loosen the cable adjusting locknuts (1).
  2. Remove the accelerator throttle cable from the bracket.
  3. Disconnect the accelerator cable from the throttle lever (3).

    Opening the throttle lever by hand will aide in the accelerator cable removal.

    4. Fig 2: Cruise Control Actuator Cover And Components
    GM347509Courtesy of GENERAL MOTORS CORP.
  4. Remove the cruise control actuator cover (1) by applying a slight outward pressure to both sides at the base of the cover.
    5. Fig 3: Locating Cruise Control Actuator
    GM347503Courtesy of GENERAL MOTORS CORP.
  5. Remove the cable attaching screw (5).
  6. Remove the accelerator throttle cable (4) from the bracket.
  7. Disconnect the accelerator throttle cable (4) from the actuator lever (1).
  8. Remove the accelerator throttle cable from the cable guide clip.
scientia non olet · About LEMON Manuals