Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Connect the accelerator throttle cable (4) to the actuator lever (1).
- Install the accelerator throttle cable (4) into the bracket.
- Secure with one screw.
Tighten: Tighten the cable screw (5) to 2 N.m (18 lb in).
- Install the cruise control actuator cover (1) by applying slight downward pressure to the cover.
- Connect the accelerator throttle cable (2) to the throttle lever (3). Opening the throttle lever by hand will aide in the accelerator throttle cable installation.
- Connect the accelerator throttle cable to the accelerator cable bracket.
- Connect the accelerator throttle cable to the cable guide clip.
- Adjust the cable adjusting locknuts to allow slight freedom of movement between the accelerator cable and the throttle lever.
- Secure with the 2 nuts (1).
Tighten: Tighten the adjusting locknuts to 8 N.m (71 lb in).
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.