LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Controls Cable Replacement (Cruise Actuator to Pedal) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Cruise Control Actuator Cover And Components
    GM347509Courtesy of GENERAL MOTORS CORP.
  1. Remove the cruise control actuator cover (1) by applying a slight outward pressure to both sides at the base of the cover.
    2. Fig 2: Locating Cruise Control Actuator
    GM347503Courtesy of GENERAL MOTORS CORP.
  2. Loosen the cable adjusting lock nuts (2).
  3. Remove the accelerator pedal cable from the bracket.
  4. Disconnect the accelerator pedal cable from the actuator lever (1). Rotating the actuator lever by hand will aide in the accelerator pedal cable removal.
  5. Remove the accelerator pedal cable from the cable guide clip.
    6. Fig 3: View of Accelerator Cable and Throttle Lever
    GM236863Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the accelerator cable from the accelerator pedal.
  7. Disconnect the 2 bolts (2) and the accelerator cable (5) and the bracket (1) at the bulkhead.
  8. Remove the accelerator cable (5) from the vehicle.
scientia non olet · About LEMON Manuals