Timing Chain Housing Installation
WARNING: This page is about a different variant/trim than selected.
- Apply a continuous bead of GM P/N 12346240 (Canadian P/N 10953493) or an equivalent to the timing chain cover mating surface.
- Apply GM P/N 12346240 (Canadian P/N 10953493) or an equivalent to the cylinder block (1).
- Install the timing chain cover.
Secure the cover using 19 bolts:
- Tighten the timing chain cover bolts (1) to 21 N.m (15 lb ft).
- Tighten the timing chain cover bolts (2) to 11 N.m (8 lb ft)
- Tighten the timing chain cover bolts (3) to 9 N.m (80 lb in).
- Tighten the timing chain cover bolts (4) to 9 N.m (80 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.