LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Cylinder Head Cover Installation

Cylinder Head Cover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Cylinder Head Cover Bolts
    GM829030Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use a new cylinder head cover gasket and new seal washers whenever the cylinder head cover replacement procedure is performed.
    Ensure that the new gasket and the new seal washers are correctly positioned during the cylinder head cover installation.
  1. Install the new cylinder head cover gasket to the cylinder head cover.
  2. Install the new seal washers to the cylinder head cover.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the cylinder head cover to the cylinder head. Secure the cover using nine bolts.

    Tighten:  Tighten the cylinder head cover bolts to 10 N.m (7 lb ft).

scientia non olet · About LEMON Manuals