Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Apply J 36850 to the VSS O-ring.
- Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS with the retaining bolt.
Tighten: Tighten the VSS speed sensor (VSS) bolt to 6 N.m (53 lb in).
- Connect the VSS electrical connector (1).
- Connect the negative battery cable.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.