LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - MTN - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Repair Instructions >> Shift Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable.
  2. Remove the lever knob and the boot.
  3. Remove the front and the rear center console halves.
  4. Remove the center air duct.
  5. Remove the shift cable retainer and the end clips at the control assembly.
  6. Remove the shift cable hold down bracket.
  7. Remove the 4 shift control mounting bolts.
  8. Remove the control assembly.
  9. Remove the shift cable retainers at the transaxle.
  10. Remove the shift cables by pulling them through the inside of the vehicle.
scientia non olet · About LEMON Manuals