LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - MTN - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Repair Instructions >> Gearshift Lever Case Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the gear shift guide bracket and the 2 bolts.

    Tighten:  Tighten the bolts to 16 N.m (12 lb ft).

  2. Install the gear shift guide case gasket.
  3. Install the gear shift guide case and the 4 bolts.

    Tighten:  Tighten the gear shift guide case bolts to 20 N.m (14 lb ft).

  4. Connect the shift cables.
  5. Install the air cleaner assembly. Refer to Air Cleaner Element Replacement in Engine Electrical.
scientia non olet · About LEMON Manuals