Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Install the rear transaxle bracket and bolts on the transaxle.
Tighten: Tighten the rear transaxle bracket bolts to 64 N.m (47 lb ft).
Install the rear transaxle mount and bolts to the body rail.
Tighten: Tighten the transaxle mount bolts to 52 N.m (38 lb ft).
Install the rear transaxle mount through bolt.
Tighten: Tighten the rear transaxle mount through bolt to 87 N.m (64 lb ft).
Remove the engine support fixture from the engine.
Install the air cleaner box.
Install the air cleaner box bolts.
Install the air filter.
Install the air cleaner hose and cap assembly.
Connect the MAF connector.
Connect the hoses to the air cleaner case assembly.
Install the battery tray and battery. Refer to Battery Replacement in Engine Electrical.
Install the hold down bracket.
Install the hold down bracket bolt and nut.
Tighten: Tighten the hold down bracket bolt and nut to 12 N.m (106 lb in).
Connect the positive and negative battery cables.