LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transmission - MK5 - Overhaul) >> Repair Instructions >> Shift and Select Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Number 2 Shift Lever Slotted Pin
    GM164009Courtesy of GENERAL MOTORS CORP.
  1. Remove the assembly from the case.
  2. Remove the E-clip and the compression spring.
  3. Using a pin punch and a hammer, driver out the slotted spring pins from the shift inner levers number 1 and number 2.
  4. Remove the shift inner lever number 2.
  5. Remove the following components:
    • The shift inner lever number 1
    • The shift interlock plate.
    6. Fig 2: Locating Compression Spring
    GM164022Courtesy of GENERAL MOTORS CORP.
  6. Using a pin punch and a hammer, driver out the slotted spring pin from the select inner lever.
  7. Remove the following components:
    • The select inner lever
    • The compression spring
    • The spring seat
    8. Fig 3: Inspecting Shift and Select Lever For Wear Or Damage
    GM164025Courtesy of GENERAL MOTORS CORP.
  8. Remove the snap ring from the lever shaft using two screwdrivers and a hammer.
  9. Remove the lever shaft and boot.
  10. Remove the shaft seal.
  11. Inspect the following parts for excessive wear or damage. Replace components as required:
    • The lever and boot
    • The select inner lever
    • The shift inner lever number 1 and number 2
    • The compression spring and seats
scientia non olet · About LEMON Manuals