Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Fastener Tightening Specifications
| Application | Specifications | |
|---|---|---|
| Metric | English | |
| Counterdrive Gear Locknut | 180 N.m | 133 lb ft |
| Counterdriven Gear Locknut | 180 N.m | 133 lb ft |
| Differential Ring Gear Bolts | 97 N.m | 72 lb ft |
| Fluid Cooler Pipe Unions | 28 N.m | 20 lb ft |
| Inlet and Outlet Fluid Cooler Pipe Unions | 28 N.m | 20 lb ft |
| Manual Control Lever Nut | 12 N.m | 9 lb ft |
| Manual Detent Spring Bolt | 10 N.m | 89 lb in |
| Manual Lever Nut | 7 N.m | 62 lb in |
| Oil Filter Bolts | 10 N.m | 89 lb in |
| Oil Pan Bolts | 5.3 N.m | 47 lb in |
| Oil Pump Bolts | 25 N.m | 18 lb ft |
| Parking Pawl Shaft Retaining Bolts | 5.5 N.m | 49 lb in |
| Park/Neutral Position (PNP) Switch Bolts | 7 N.m | 62 lb in |
| Solenoid Retaining Bolts | 10 N.m | 88 lb in |
| Solenoid Wire Harness Retaining Bolt | 5.5 N.m | 49 lb in |
| Spring Guide Sleeve Retaining Bolts | 13 N.m | 10 lb ft |
| Transaxle Apply Tube Clamps | 5.5 N.m | 49 lb in |
| Transaxle Housing Bolts | 28 N.m | 20 lb ft |
| Transaxle Rear Case Cover | 10 N.m | 89 lb in |
| Transmission Case Plate No.1 Bolt | 10 N.m | 89 lb in |
| Transmission Case Plate No.2 Bolts | 10 N.m | 89 lb in |
| Transmission Case Plate No.3 Torx | 7.5 N.m | 66 lb in |
| Transmission Wire Harness Bolt | 5.5 N.m | 49 lb in |
| Underdrive Roller Bearing Retainer | 17 N.m | 13 lb ft |
| Valve Body Assembly Bolts | 10 N.m | 89 lb in |
| 2nd Coast Brake Band Guide Plate Bolt | 5.5 N.m | 47 lb in |