LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - Mu4 - Overhaul) >> Repair Instructions >> Rear Planetary Gearset Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the low one-way clutch sprag assembly into the low one-way clutch outer race with the flanged side of the sprag assembly toward the finished (shiny) side of the low one-way clutch outer race.
  2. Install the following components into both sides of the low one-way clutch outer race:
    • The low one-way clutch retainers
    • The low one-way clutch snap rings
    3. Fig 1: Checking Low One-Way Clutch By Rotating Rear Planetary Carrier
    GM165067Courtesy of GENERAL MOTORS CORP.
  3. Inspect the low one-way clutch after assembly by placing the low one-way clutch onto the rear planetary carrier, holding the low one-way clutch stationary and rotating the rear planetary carrier.
    • The rear planetary carrier (1) should turn freely in a counterclockwise direction and should not turn in a clockwise direction.
    • If the low one-way clutch is correctly installed (finished side up) on the rear planetary carrier and the rear planetary carrier can be turned clockwise, replace the low one-way clutch.
scientia non olet · About LEMON Manuals