Tools Required

J 38358-A  Support Remover/Installer

Fig 1: View Of Low One-Way Clutch Snap Ring
Courtesy of GENERAL MOTORS CORP.
1. Use the J 38358-A  in order to remove the low one-way clutch snap ring (2) from the transaxle case.
Fig 2: Identifying J 38358-A
Courtesy of GENERAL MOTORS CORP.
2. Remove the low one-way clutch and the rear planetary carrier (1) from the rear planetary ring gear and the 1st-reverse brake.
Fig 3: Locating Rear Planetary Carrier Thrust Washers
Courtesy of GENERAL MOTORS CORP.
3. Remove the two thrust washers (1) from the rear planetary carrier (3).
Fig 4: View Of One-Way Clutch
Courtesy of GENERAL MOTORS CORP.
4. Remove the one-way clutch (1) from the rear planetary carrier (2).
Fig 5: Locating Rear Planetary Carrier Thrust Bearing & Race
Courtesy of GENERAL MOTORS CORP.
5. Remove the rear planetary carrier thrust bearing (2) and the race (3) from the rear planetary ring gear and intermediate shaft (1).