LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission - Mu4 - Overhaul) >> Repair Instructions >> Intermediate Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intermediate Shaft Seal Ring
    GM165080Courtesy of GENERAL MOTORS CORP.
  1. Remove the intermediate shaft seal ring (1) from the intermediate shaft.
    2. Fig 2: Removing Rear Planetary Ring Gear Snap Ring
    GM165083Courtesy of GENERAL MOTORS CORP.
  2. Remove the following components from the rear planetary ring gear flange on the intermediate shaft:
    • The rear planetary ring gear snap ring (2)
    • The rear planetary ring gear
  3. Clean all the intermediate shaft and countershaft drive gear components and dry thoroughly.
  4. Inspect the following components for excessive wear or damage and replace as necessary:
    • The intermediate shaft
    • The rear planetary ring gear flange
    • The countershaft drive gear
  5. Inspect the countershaft drive gear inner and outer bearings for excessive wear or damage. Replace the countershaft drive gear inner bearing and the countershaft drive gear as necessary.
scientia non olet · About LEMON Manuals