LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable.
  2. Remove the Lower Instrument Panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower .
    3. Fig 1: Removing/Installing Clevis Clip And Pin
    GM885330Courtesy of GENERAL MOTORS CORP.
  3. Remove the clevis clip and the pin.
  4. Disconnect the Clutch Pedal Position (CPP) switch electrical connector.
  5. Disconnect the Cruise Control Release (CCR) switch electrical connector.
    6. Fig 2: Pedal Assembly Bracket Retaining Nuts And Retaining Bolt
    GM885331Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 pedal assembly bracket retaining nuts and the 1 retaining bolt.
  7. Remove the clutch pedal assembly from the vehicle.
scientia non olet · About LEMON Manuals