LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable.
    2. Fig 1: CPP Switch Electrical Connector
    GM235968Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the CPP switch.
  3. Remove the CPP switch from the clutch and the brake pedal bracket by turning the CPP switch counterclockwise.
  4. Remove the CPP switch lock nut from the CPP switch.
  5. Inspect the CPP switch for excessive wear or damage. Replace the switch as necessary.
scientia non olet · About LEMON Manuals