Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Removing/Installing Torque Converter From Transmission

Courtesy of GENERAL MOTORS CORP.

Install the Input shaft seal to input shaft.
Install the following to the torque converter:
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
1. Install the torque converter seal to transmission.
2. Install the converter seal bolts to transmission.
  Tighten: Tighten the torque converter seals bolts to 3 N.m (26 lb in).
Install the torque converter (1) to the transmission. Push the torque converter into position while rotating. The torque converter must be fully seated.
Install the transmission. Refer to Transaxle Replacement .