LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - Mu4 - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Repair Instructions >> Park/Neutral Position Switch >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Manual Lever
    GM857097Courtesy of GENERAL MOTORS CORP.
  1. Remove the shift cable retaining clip.
  2. Disconnect the cable from the bracket.
  3. Remove the shift cable retaining nut, then disconnect the cable from the manual lever.
    4. Fig 2: PNP Switch And Electrical Connector
    GM242877Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the PNP switch electrical connector (1) from the PNP switch.
    5. Fig 3: Lock Plate, Manual Shaft Nut And Bolts
    GM857099Courtesy of GENERAL MOTORS CORP.
  5. Remove 1 nut, 1 lock washer and the manual lever from the manual shaft.
  6. Unstake the lock plate (1) behind the manual shaft nut (3).
  7. Remove the manual shaft nut and the lock plate from the PNP switch.
  8. Remove the 2 bolts and the PNP switch from the transaxle.
scientia non olet · About LEMON Manuals