LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - Mu4 - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Repair Instructions >> Drive Axle Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using J 46007  and. See Special Tools .J 42176-10  and J 42176  , install the new drive axle shaft seal into the transaxle. See Special Tools .
  2. Apply J 36850  to the new drive axle shaft seal lip.
  3. Install the drive axle into the vehicle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
  4. Install the front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Install the left splash shield on the vehicle, if removed. Refer to Splash Shield Replacement - Engine - Left in Body Front End.
  6. Install the right splash shield on the vehicle, if removed. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
    7. Fig 1: Differential Drain Plug
    GM870108Courtesy of GENERAL MOTORS CORP.
  7. Install the transaxle differential drain plug.

    Tighten:  Tighten the drain plug to 17 N.m (13 lb ft).

  8. Lower the vehicle.
  9. Refill the transaxle, as necessary.
scientia non olet · About LEMON Manuals