LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - Mu4 - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Repair Instructions >> Automatic Transmission Mount Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the engine support fixture to support the engine. Refer to Engine Support Fixture in Engine Mechanical-1.8L (LV6).
    2. Fig 1: Rear Mount Through Bolt
    GM865489Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear mount through bolt.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    4. Fig 2: Rear Mount To Transmission Support Bolt And Nuts
    GM865493Courtesy of GENERAL MOTORS CORP.
  4. Remove the 3 nuts and 1 bolt securing the rear mount to the transmission support.
  5. Lower the vehicle.
  6. Remove the rear transaxle mount from the vehicle.
scientia non olet · About LEMON Manuals