LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - Mu4 - Service, Removal & Installation, Troubleshooting & Diagnostics) >> Diagnostic Information and Procedures >> DTC P0770 >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch to LOCK.
  2. Connect the scan tool to data link connector (DLC).
  3. Turn the ignition switch to ON.
  4. Clear the DTC, the pending DTC, and the freeze frame data in PCM memory by using the scan tool.
  5. Start the engine and warm up to normal operating temperature.
  6. Use the scan tool to monitor the operation of the TCC solenoid.
  7. Accelerate vehicle in Drive (D) range and drive at 80 km/h (50 mph) for 10 seconds.
  8. Stop the vehicle.
  9. Test for a pending DTC with the scan tool.
scientia non olet · About LEMON Manuals