Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
Inspect for the following conditions:
- An open or shorted shift solenoid #1
- Faulty electrical circuits/open or short to ground between the shift solenoid #1 and the PCM
- A faulty PCM
An intermittent may be caused by the following conditions:
- A poor connection
- Rubbed through wire insulation
- A broken wire inside the insulation
Inspect the PCM harness connectors for the following conditions:
- Backed out terminals
- Improper mating
- Broken locks
- Improperly formed or damaged terminals
- Poor terminal-to-wire connections
Perform the following steps if DTC P0753 cannot be duplicated:
- Read the information in the freeze frame data.
- Use the data to determine the vehicle operating conditions when the DTC was set.
Inspect the wiring. If any wiring repairs are necessary, refer to DIAGNOSTIC INFORMATION AND PROCEDURES in WIRING SYSTEMS.