LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Vacuum Brake Booster Replacement >> Adjustment Procedure

Adjustment Procedure

    Fig 1: View Of Master Cylinder & Piston
    GM172785Courtesy of GENERAL MOTORS CORP.
  1. Place the J 39567  on the master cylinder (1). See Special Tools .
  2. Push the J 39567  pin down until it touches the master cylinder piston (2). See Special Tools .
  3. Remove the J 39567  from the master cylinder. See Special Tools .
    4. Fig 2: View Of Booster Assembly & Booster Piston Rod
    GM172794Courtesy of GENERAL MOTORS CORP.
  4. Turn the J 39567  upside down. See Special Tools .
  5. Set the J 39567  on the booster (1). See Special Tools .

    Specification:  The clearance (2) between the booster piston rod (3) and the J 39567  should be 0 mm (0 in). See Special Tools .

    6. Fig 3: Adjusting Booster Piston Rod
    GM172797Courtesy of GENERAL MOTORS CORP.
  6. If the measurement does not equal the specification, use the J 37767  in order to hold the booster piston rod (1). See Special Tools .
  7. Turn the adjusting screw of the piston rod in order to adjust the clearance.
scientia non olet · About LEMON Manuals