LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Master Cylinder Components
    GM830248Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Brake Fluid Caution in Cautions and Notices.
    NOTE: Refer to Filling the Master Cylinder Notice in Cautions and Notices.
  1. Lubricate the grommets (4,7) with new brake fluid.
  2. Install the grommets to the master cylinder.
  3. Install the reservoir to the master cylinder.
  4. Install the screw (5).
  5. Install the reservoir diaphragm (2).
  6. Fill the reservoir and install the cap. Refer to Master Cylinder Reservoir Filling .
  7. Inspect the master cylinder for fluid leakage.
  8. Connect the brake fluid level switch connector.
scientia non olet · About LEMON Manuals