LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Brake Hose Replacement - Rear (Drum Brakes) >> Installation Procedure

Installation Procedure

    Fig 1: Brake Hose Components (Drum Brakes)
    GM880321Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps or plugs from the brake pipes (2,7).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake hose (1) and the 2 retainers (4,5) to the brake pipes (2,7).

    Tighten:  Tighten the fittings to 15.2 N.m (11.21 lb ft).

    3. CAUTION: Refer to Brake Fluid Caution in Cautions and Notices.
    NOTE: Refer to Filling the Master Cylinder Notice in Cautions and Notices.
  3. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .
  4. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals