LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Body Side Roof Drip >> Removal Procedure

Removal Procedure

    Fig 1: Protective Tape, Roof Drip Molding And Flat Bladed Tool
    GM856727Courtesy of GENERAL MOTORS CORP.
  1. Apply protective tape (1) around the roof drip molding (3).
  2. Use a flat bladed tool (2) to remove roof drip molding (3)
    3. Fig 2: Roof Drip Molding, Clips And Roof
    GM856719Courtesy of GENERAL MOTORS CORP.
  3. Disengage the roof drip molding (1) from the clip (2) and remove the roof drip molding (1) from the roof (3).
scientia non olet · About LEMON Manuals