LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Torrent FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Retainer Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of I/P Retainer
    GM1347080Courtesy of GENERAL MOTORS CORP.
  1. Align the I/P retainer to the cross beam.
  2. Fig 2: Removing/Installing I/P Retainer Screws & Bolts
    GM1350099Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws and the bolts which hold the I/P retainer to the cross beam. Begin at the center and work toward each side.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  4. Install the left and the right carpet retainers. Refer to Carpet Retainer Replacement - Front in Interior Trim.
  5. Install the inflatable restraint I/P module. Refer to Inflatable Restraint Instrument Panel Module Replacement in SIR.
  6. Fig 3: View Of Power Mirror Switch & Dimmer Switch Panel
    GM1344274Courtesy of GENERAL MOTORS CORP.
  7. Install the panel which contains the power mirror switch and the dimmer switch.
  8. Install the right side I/P trim panel. Refer to Console Trim Panel Replacement - Right .
  9. Install the steering column filler. Refer to Steering Column Filler Replacement .
  10. Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) .
  11. Install the I/P outer trim covers. Refer to Console Trim Panel Replacement - Right  and to Console Trim Panel Replacement - Left .
  12. Install the BCM module from the I/P. Refer to Body Control Module Replacement in Computer/Integrating Systems.
  13. Install the radio. Refer to Radio Replacement in Entertainment.
  14. Install the center trim bezel. Refer to Trim Bezel Replacement - Center .
  15. Install the instrument cluster bezel. Refer to Instrument Panel Cluster (IPC) Replacement .
  16. Install the upper trim pad. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper .
  17. Install the window garnish moldings. Refer to Windshield Upper Garnish Molding Replacement in Interior Trim.
  18. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 in SIR.
  19. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  20. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.