Scan Tool Data List
The scan tool data lists contain all the instrument panel, gages, and console related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.
Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle in Vehicle DTC Information.
Use the scan tool data lists only after the following is determined:
- There is no published DTC procedure nor published symptom procedure for the customer concern.
- The DTC or symptom procedure indicated by the diagnostic system check does not resolve the customer concern.
The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/High Beams Off/Doors Closed/Trunk Closed/Park Brake Unapplied | |||
| Battery 1 | Accessory Switch Inputs Exterior Lamps Interior Lamps Door Locks Wiper/Washer Security Data |
Volts | 9-16 V (Varies) |
| Coolant Gage Position | Accessory | % | Varies |
| Driver Door Switch | Switch Inputs Interior Lamps |
Open/Closed | Closed |
| Fuel Gauge Position | Accessory | % | Varies |
| High Beam Switch | Switch Inputs Exterior Lamps |
On/Off | Off |
| I/P Dimmer Input | Interior Lamps | Volts | Varies |
| I/P Dimmer Output | Interior Lamps | % | Varies |
| Ignition 1 Input | Security Data | On/Off | On |
| Ignition 2 Input | Security Data | On/Off | On |
| Key in Ignition | Switch Inputs Interior Lamps |
Yes/No | Yes |
| Liftgate Ajar Switch | Switch Inputs | Open/Closed | Closed |
| Low Beam Input | Exterior Lamps | Volts | Varies |
| Low Brake Fluid | Switch Inputs | Yes/No | No |
| Low Coolant | Switch Inputs | On/Off | Off |
| Oil Life Reset Switch | Switch Inputs | On/Off | Off |
| Park Brake Switch | Switch Inputs | On/Off | Off |
| Parklamp Switch | Switch Inputs Exterior Lamps |
On/Off | Off |
| Pass Door Switches | Switch Inputs Interior Lamps |
Open/Closed | Closed |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Seat Belt Buckled/High Beams Off/Park Brake Unapplied | |||
| Software Date - Day | ID Information | Numeric | Varies |
| Software Date - Month | ID Information | Numeric | Varies |
| Software Date - Year | ID Information | Numeric | Varies |
| Software ID | ID Information | Numeric | Varies |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine Idling/Normal Operating Temperature | |||
| Engine Speed | Engine Data 1 Engine Data 2 Engine Data 3 Cruise Control Data EVAP Data HO2S Data Fuel Trim Data Misfire Data |
RPM | 100 RPM from Desired Idle Speed |
| ECT Sensor | Engine Data 1 Engine Data 2 Engine Data 3 EVAP Data Fuel Trim Data Misfire Data |
Celsius (Fahrenheit) | 85-105°C (185-220°F) |
| Engine Oil Life Remaining | Engine Data 2 Engine Data 3 |
% | Varies |
| Engine Oil Pressure Sensor | Engine Data 3 | Volts | Varies |
| Engine Oil Pressure Switch | Engine Data 3 | OK/Low | OK |
| Fuel Level Sensor | EVAP Data | % | Varies |
| Fuel Level Sensor | EVAP Data | Volts | Varies |
| Ignition 1 Signal | Engine Data 1 Engine Data 2 Engine Data 3 Cruise Control Data EVAP Data HO2S Data Fuel Trim Data |
Volts | 9-16 V (Varies) |
| Reduced Engine Power | Engine Data 1 Engine Data 3 Cruise Control Data HO2S Data |
Active/Inactive | Inactive |
| Vehicle Speed Sensor | Engine Data 1 Engine Data 2 Engine Data 3 Cruise Control Data EVAP Data HO2S Data Fuel Trim Data Misfire Data |
km/h (mph) | 0 km/h (0 mph) |