Toe Link Replacement
Toe Link Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation
. |
|
| 1 | Nut, Toe Link Retaining Tip: Use the appropriate tool to remove the toe link ball joint from the rear knuckle. Clean off threads and apply a small amount of penetrating oil to the thread of the link and allow to sit for a very minutes. This will aid in the removal of the nut and not damage the threads. Tighten: 30 N.m (22 lb ft) +/- 150° |
| 2 | Nut, Toe Link to Frame Tighten: 60 N.m (44 lb ft) |
| 3 | Link, Toe Tip: Adjust the rear toe. Refer to Rear Toe Adjustment . |