Receiver Replacement - Digital Radio

Fig 1: Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the rear compartment trim. Refer to Compartment Trim Panel Replacement - Rear . Program the digital radio receiver after replacement. Refer to Control Module References .
1	Nuts, Digital Radio Receiver Bracket (Qty: 2) Tighten: 10 N.m (89 lb in)
2	Bracket Assembly, Digital Radio Receiver
3	Nuts, Digital Radio Receiver (Qty: 3) Tighten: 10 N.m (89 lb in)
4	Receiver Assembly, Digital Radio