Wheel Bearing/Hub Replacement - Rear

Fig 1: Wheel Bearing/Hub - Rear

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation . Remove the brake caliper mounting bracket. Refer to Brake Caliper Bracket Replacement - Rear .
1	Nut, Drive Axle Retaining Tighten:
2	Bolt, Wheel/Hub Mounting Tighten:
3	Hub, Wheel Tip: Using a small flat-blade screw driver, remove the speed sensor wiring harness from the upper control arm. Disconnect the speed sensor electrical connector.