LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> GTO Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Extension Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Right Side I/P Lower Extension & Rear Compartment Release Switch
    GM1359055Courtesy of GENERAL MOTORS CORP.
  1. Install the rear compartment release switch (3). Refer to Rear Compartment Lid Switch Replacement in Body Rear End.
  2. Connect the wiring connector (4) to the rear compartment release switch (3).
  3. Install the extension (2) to the instrument panel, making sure the retaining clip (5) is engaged.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screw attaching the front floor console duct, if removed.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  5. Install the three screws (1) attaching the lower extension (2) to the instrument panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the console trim plate. Refer to Trim Plate Replacement - Console .
  7. Install the left knee bolster trim panel, if removed. Refer to Knee Bolster Replacement - Left .
  8. Install the instrument panel compartment/ashtray. Refer to Ashtray Replacement .
scientia non olet · About LEMON Manuals