Installation Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
- Install or connect the fluid cooler inlet pipe, outlet pipe and bracket to the transaxle. Secure the pipe bracket to the transaxle with 1 bolt.
Tighten:
- Tighten the transaxle inlet and outlet fluid cooler pipe flare nuts to 35 N.m (25 lb ft).
- Tighten the fluid cooler pipe bracket bolt to 5 N.m (44 lb in).
- Install the following to the transaxle and fluid cooler:
- The fluid cooler inlet hose to the fluid cooler inlet pipe. Secure with the 1 clamp.
- The fluid cooler inlet hose to the transaxle fluid cooler. Secure with the 1 clamp.
- The fluid cooler outlet hose to the fluid cooler outlet pipe. Secure with the 1 clamp.
- The fluid cooler outlet hose to the transaxle fluid cooler. Secure with the 1 clamp.
- Remove the drain pan from under the transaxle fluid cooler.
- Refill the transaxle with AC Delco T-IV (GM Part No. 88900925), as necessary.